Where can I find the Media Detailed Settings for each Media Type?
You can print a list from: GARO Status Monitor -> Information Tab -> Print Media Detailed Settings
However, don't bother. You will get a 6 page cryptic list which I will summarize for you in half a page. All default Detailed Media Settings are identical for all of the Media Types with just a few exceptions. Here are the settings for almost all of the Media Types:
Roll Drying Time - Off
Scan Wait Time - Off
Cut Speed - Fast
Near End Roll Margin - 3 mm
Near End Sheet Margin - 3 mm
Trim Edge First - No Cutting
Cutting Mode - Automatic
Tray Source - Top
Borderless Margin - Automatic
Cut Dust Reduction - Off
Skew Check Lv. - Standard
Vacuum Strength - Automatic
Feed Priority - Automatic
Head Height - Automatic
Calibration - OK
Exceptions:
Default Cutting Mode is Eject for: HW Glossy Photo, HW SemiGloss Photo, Backprint Film and CAD Matte Film
POP Board has Cut Speed - Slow and Tray Source - Front
Note: The two settings you would be most likely to change, Vacuum Strength and Head Height, list "Automatic", so you don't really know how much stronger/higher to set them if you are getting printhead strikes on the paper.
Where can I find the Media Detailed Settings for each Media Type?
You can print a list from: GARO Status Monitor -> Information Tab -> Print Media Detailed Settings
However, don't bother. You will get a 6 page cryptic list which I will summarize for you in half a page. All default Detailed Media Settings are identical for all of the Media Types with just a few exceptions. Here are the settings for almost all of the Media Types:
Exceptions:
Note: The two settings you would be most likely to change, Vacuum Strength and Head Height, list "Automatic", so you don't really know how much stronger/higher to set them if you are getting printhead strikes on the paper.